Subaru IMPREZA GD 2007 Series Manual page 2867

asieps_tobira_IM_US.book 44 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
E: INSPECTION
1) Bearing
Replace the bearings in the following cases.
• In case of broken or rusty bearings
• In case of worn or damaged bearings
• When the bearings fail to turn smoothly or emit
noise in rotation after gear oil lubrication.
2) Drive gear
If the drive gear tooth surface and shaft are exces-
sively broken or damaged, replace the drive gear.
3) Measure the clearance between snap ring and
inner race of ball bearing with a thickness gauge.
Clearance:
0.01 — 0.15 mm (0.0004 — 0.0059 in)
If the measurement is not within specification, se-
lect a suitable snap ring and replace it.
Snap ring (Outer-30)
Part No.
805030041
805030042
805030043
Transfer Drive Gear
MT-00138
Thickness mm (in)
1.53 (0.0602)
1.65 (0.0650)
1.77 (0.0697)
5MT-44