Subaru IMPREZA GD 2007 Series Manual page 3318

asieps_tobira_IM_US.book 52 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DIFFERENTIALS
16) Apply loctite on the drive pinion shaft thread
and new self-locking nut seat.
Loctite:
THREE BOND 1324 (Part No. 004403042) or
equivalent
17) Tighten the self-locking nut within the specified
torque range so that the companion flange preload
becomes the same value as that before replacing
the oil seal.
Except for STI model
ST 498427200 FLANGE WRENCH
STI model
ST 18633AA000 WRENCH COMPL
NOTE:
Use a new self-locking nut.
Tightening torque:
181.5 N·m (18.5 kgf-m, 134 ft-lb)
ST
18) Hereafter, reassemble in the reverse order of
disassembly.
19) After installing, fill the differential carrier with
gear oil up to the bottom of the filler plug hole. <Ref.
to DI-20, Differential Gear Oil.>
Rear Differential Front Oil Seal
DI-00199
DI-52