Subaru IMPREZA GD 2007 Series Manual page 3402

asieps_tobira_IM_US.book 6 ページ ２０１２年１月１７日 火曜日 午後３時４８分
PARKING BRAKE
4. Parking Brake Assembly
(Rear Disc Brake)
A: REMOVAL
1) Release the parking brake.
2) Remove the two mounting bolts and remove the
brake caliper assembly
(1) Brake caliper ASSY
3) Suspend the brake caliper assembly so that the
hose is not stretched.
4) Remove the disc rotor.
NOTE:
If the disc rotor is difficult to remove, try the follow-
ing two methods in order.
(1) Turn the adjusting screw using a flat tip
screwdriver until the brake shoe moves ade-
quately away from the disc rotor.
(2)
(1)
(4)
(1) Adjusting screw
(2) Adjusting hole cover (rubber)
(3) Flat tip screwdriver
(4) Back plate
Parking Brake Assembly (Rear Disc Brake)
(1)
BR-00034
(3)
BR-00155
PB-6
(2) If disc rotor is seized on the hub, drive the
disc rotor out by pushing two 8 mm bolts in
holes B on the rotor.
A
5) Remove the shoe return spring from the parking
brake assembly.
6) Remove the front shoe hold down spring and pin
with pliers.
7) Remove the strut and strut spring.
8) Remove the adjuster assembly from the parking
brake assembly.
9) Remove the brake shoe.
10) Remove the rear shoe hold down spring and
pin with pliers.
11) Remove the parking brake cable from lever.
(1) Parking brake cable
(2) Lever
12) Using a flat tip screwdriver, raise the retainer.
Remove the lever and washer from brake shoe.
B
BR-00036
PB-00013
PB-00014