Subaru IMPREZA GD 2007 Series Manual page 2866

asieps_tobira_IM_US.book 43 ページ ２０１２年１月１７日 火曜日 午後３時４８分
11.Transfer Drive Gear
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 5MT-25, REMOVAL,
Manual Transmission Assembly.>
2) Remove the back-up light switch and the neutral
position switch. <Ref. to 5MT-35, REMOVAL,
Switches and Harness.>
3) Remove the transfer case together with the ex-
tension case assembly. <Ref. to 5MT-39, REMOV-
AL, Transfer Case and Extension Case
Assembly.>
4) Remove the extension case assembly.
5) Remove the transfer driven gear.
6) Remove the transfer drive gear.
B: INSTALLATION
1) Install the transfer drive gear.
Tightening torque:
26 N·m (2.7 kgf-m, 20 ft-lb)
2) Install the transfer driven gear.
3) Install the extension case assembly.
4) Install the transfer case and the extension case
assembly. <Ref. to 5MT-39, INSTALLATION,
Transfer Case and Extension Case Assembly.>
5) Install the back-up light switch & neutral position
switch. <Ref. to 5MT-35, INSTALLATION, Switch-
es and Harness.>
6) Install the manual transmission assembly to the
vehicle. <Ref. to 5MT-28, INSTALLATION, Manual
Transmission Assembly.>
Transfer Drive Gear
MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
1) Remove the snap ring.
2) Remove the ball bearing.
D: ASSEMBLY
MT-00133
1) Set the ST against the inner race of the bearing,
and install the drive shaft.
ST 398177700
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
MT-00133
2) Install the snap ring on the transfer drive shaft.
3) Inspect the clearance between the snap ring and
the ball bearing. <Ref. to 5MT-44, INSPECTION,
Transfer Drive Gear.>
5MT-43
MT-00135
MT-00136
INSTALLER
ST
MT-00137