Subaru IMPREZA GD 2007 Series Manual page 2976

asieps_tobira_IM_US.book 71 ページ ２０１２年１月１７日 火曜日 午後３時４８分
11) Install the check ball, check spring, new O-ring
and check plugs.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
(A) Check plug
(B) O-ring
(C) Checking spring
(D) Check ball
12) Attach the bolt and a new gasket.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
13) Use a screw driver to shift to the 4th gear posi-
tion.
Main Shaft Assembly
(A)
(B)
(C)
(D)
MT-00554
MT-00546
6MT-71
MANUAL TRANSMISSION AND DIFFERENTIAL
14) Install the reverse idler holder.
(A)
(A) Reverse idler holder
15) Install the striking rod.
16) Install the transmission case. <Ref. to 6MT-64,
INSTALLATION, Transmission Case.>
17) Install the selected main shaft snap ring and
washers.
18) Install the oil pump. <Ref. to 6MT-61, INSTAL-
LATION, Oil Pump.>
19) Install the center differential. <Ref. to 6MT-58,
INSTALLATION, Center Differential.>
20) Install the transfer driven gear. <Ref. to 6MT-
56, INSTALLATION, Transfer Driven Gear.>
21) Install the extension case. <Ref. to 6MT-44, IN-
STALLATION, Extension Case.>
22) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-41,
INSTALLATION, Oil Pipe.> <Ref. to 6MT-43, IN-
STALLATION, Neutral Position Switch.> <Ref. to
6MT-42, INSTALLATION, Back-up Light Switch.>
23) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
NOTE:
Individual sleeves and hubs meet at a specified po-
sition. Before disassembly, mark the meeting posi-
tion of the sleeve and hub.
1) Affix the ST to the work table.
ST 18664AA000 BASE
2) Flatten the nut tab.
MT-00544