Subaru IMPREZA GD 2007 Series Manual page 3310

asieps_tobira_IM_US.book 44 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DIFFERENTIALS
16) Install a new oil seal using ST.
NOTE:
• Press-fit until the oil seal end comes 1 mm (0.04
in) inward from end of carrier.
• Apply grease between the oil seal lips.
ST 498447120 INSTALLER
ST
17) Press-fit the companion flange with ST1, ST2
and ST3.
ST1 899874100 INSTALLER
ST2 399780104 WEIGHT
ST3 498937110 HOLDER
NOTE:
Be careful not to damage the bearing.
ST1
ST2
18) Apply loctite on the drive pinion shaft thread
and new self-locking nut seat.
Loctite:
THREE BOND 1324 (Part No. 004403042) or
equivalent
19) Attach the self-locking nut. Tighten it using the
ST.
ST 18633AA000 WRENCH COMPL
Rear Differential
DI-00089
ST3
ST2
DI-00323
ST
DI-00071
DI-44
20) Check the initial torque and initial load.
Initial load:
24.1 — 38.6 N (2.5 — 3.9 kgf, 5.4 — 8.7 lb)
Initial torque:
0.98 — 1.57 N·m (0.10 — 0.16 kgf-m,
0.72 — 1.16 ft-lb)
21) Install the driven gear to the differential case.
NOTE:
• Before installing bolts, apply Loctite to bolt
threads.
• Make sure there is no clearance between the dif-
ferential case and driven gear.
Loctite:
THREE BOND 1324 (Part No. 004403042) or
equivalent
NOTE:
Tighten diagonally while gently tapping the bolt
heads.
Tightening torque:
103 N·m (10.5 kgf-m, 76 ft-lb)
DI-00117
DI-00481
DI-00068