Subaru IMPREZA GD 2007 Series Manual page 3264

asieps_tobira_IM_US.book 55 ページ ２０１２年１月１７日 火曜日 午後３時４８分
15.Stop Light Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the stop light switch connector.
3) Loosen the nuts, unscrew the stop light switch,
and remove stop light switch.
(1) Stop light switch
B: INSTALLATION
1) Install the stop light switch onto the bracket with
screws and position it with the nut.
2) Adjust the stop light switch position, and then
tighten the nut. <Ref. to BR-56, ADJUSTMENT,
Stop Light Switch.>
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
Stop Light Switch
C: INSPECTION
1) If the stop light switch does not operate properly
(or if it is not secured at the specified position), re-
place with a new part.
Specified position L:
2 mm (0.079 in)
(1)
BR-00107
2) Measure the clearance between the threaded
end of the stop light switch and the stopper.
CAUTION:
Be careful not to rotate the stop light switch.
Stop light switch clearance A:
0.3 mm (0.012 in)
T
BR-00108
3) If it is not within the specification, adjust it by ad-
justing the position of the stop light switch.
CAUTION:
Be careful not to rotate the stop light switch.
BR-55
L
(1)
A
(2)
(3)
(1) Stop light switch
(2) Stopper
(3) Brake pedal
BRAKE
BR-00109
BR-00110