Subaru IMPREZA GD 2007 Series Manual page 2452

asieps_tobira_IM_US.book 51 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2. TIMING BELT
1) Preparation for installation of automatic belt ten-
sion adjuster assembly. <Ref. to ME(H4DOTC)-50,
AUTOMATIC BELT TENSION ADJUSTER AS-
SEMBLY AND BELT IDLER, INSTALLATION,
Timing Belt.>
2) Align the mark (A) on crank sprocket with the
mark on oil pump cover at cylinder block.
(A)
3) Align single line mark (A) on the exhaust cam
sprocket (RH) with notch (B) on timing belt cover.
(A)
(B)
4) Align single line mark (A) on the intake cam
sprocket (RH) with notch (B) on timing belt cover.
(Make sure that the double lines (C) on intake and
exhaust camshaft sprockets are aligned.)
(B)
(A)
(C)
Timing Belt
5) Align the single line mark (A) on exhaust cam
sprocket (LH) with notch (B) on timing belt cover by
turning the sprocket counterclockwise (as viewed
from front of engine).
6) Align the single line mark (A) on intake cam
sprocket (LH) with notch (B) on timing belt cover by
turning the sprocket clockwise (as viewed from
front of engine).
ME-00081
(Make sure that the double line marks (C) on intake
and exhaust cam sprockets are aligned.)
ME-00082
ME-03133
ME(H4DOTC)-51
MECHANICAL
(B)
(A)
ME-00084
(B)
(A)
(C)
ME-03135