Subaru IMPREZA GD 2007 Series Manual page 2442

asieps_tobira_IM_US.book 41 ページ ２０１２年１月１７日 火曜日 午後３時４８分
14) Tighten the nuts which hold lower side of trans-
mission to engine.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
15) Tighten the nuts which install the front cushion
rubber onto crossmember.
Tightening torque:
85 N·m (8.7 kgf-m, 62.7 ft-lb)
NOTE:
Make sure the front cushion rubber mounting bolts
(A) and locator (B) are securely installed.
(B) (A)
16) Install the ATF cooler pipe to frame. (AT model)
17) Install the center exhaust pipe. <Ref. to
EX(H4DOTC)-11, INSTALLATION, Center Ex-
haust Pipe.>
18) Lower the vehicle.
19) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
20) Connect the following connectors and termi-
nals.
(1) Engine ground terminal
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connector
(5) Power steering switch connector
21) Adjust after connecting the cables.
22) Install the intercooler. <Ref. to IN(H4DOTC)-
14, INSTALLATION, Intercooler.>
Engine Assembly
23) Install the air cleaner case and air intake boot.
<Ref. to IN(H4DOTC)-10, INSTALLATION, Air
Cleaner Case.>
24) Install the A/C pressure hoses.
NOTE:
Use new O-rings.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
ME-00040
25) Install the radiator. <Ref. to CO(H4DOTC)-26,
INSTALLATION, Radiator.>
26) Install the coolant filler tank. <Ref. to
CO(H4DOTC)-35, INSTALLATION, Coolant Filler
Tank.>
27) Install the secondary air pump. <Ref. to
EC(H4DOTC)-9, INSTALLATION, Secondary Air
Pump.>
28) Install the battery in the vehicle, and connect
cables.
29) Fill engine coolant. <Ref. to CO(H4DOTC)-19,
FILLING OF ENGINE COOLANT, REPLACE-
MENT, Engine Coolant.>
(A) (B)
30) Check the ATF level and replenish it if neces-
ME-02689
sary. (AT model) <Ref. to 4AT-28, INSPECTION,
Automatic Transmission Fluid.>
31) Charge the A/C system with refrigerant. <Ref.
to AC-20, PROCEDURE, Refrigerant Charging
Procedure.>
32) Remove the front hood stay, and close the front
hood.
33) Lower the vehicle from the lift.
ME(H4DOTC)-41
MECHANICAL
ME-02686