Subaru IMPREZA GD 2007 Series Manual page 2440

asieps_tobira_IM_US.book 39 ページ ２０１２年１月１７日 火曜日 午後３時４８分
26) Support the transmission with a garage jack.
CAUTION:
Doing this is very important to prevent the
transmission from lowering due to its own
weight.
(A) Transmission
(B) Garage jack
CAUTION:
Before removing the engine away from trans-
mission, check to be sure no work has been
overlooked.
27) Separate the engine and transmission.
(1) Remove the starter. <Ref. to SC(H4SO)-8,
REMOVAL, Starter.>
(2) Set the ST to torque converter clutch case.
(AT model)
ST 498277200 STOPPER SET
(3) Remove the bolts which hold upper side of
transmission to engine.
28) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
Engine Assembly
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
29) Remove the front cushion rubbers.
B: INSTALLATION
(A)
1) Attach the clutch release fork and bearing to the
(B)
transmission. (MT model) <Ref. to CL-18, INSTAL-
LATION, Release Bearing and Lever.>
2) Install the front cushion rubbers.
Tightening torque:
ME-00215
3) Position the engine in engine compartment and
align it with transmission.
NOTE:
Be careful not to damage adjacent parts or body
panels with crank pulley, oil level gauge, etc.
4) Apply a small amount of grease to the splines of
the main shaft. (MT model)
5) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
ST
ME-00049
6) Remove the lifting device and wire ropes.
7) Remove the garage jack.
ME-00050
ME(H4DOTC)-39
(3) Move the engine horizontally until main
shaft is withdrawn from clutch cover.
(4) Slowly move the engine away from engine
compartment.
35 N·m (3.6 kgf-m, 25.8 ft-lb)
50 N·m (5.1 kgf-m, 37 ft-lb)
MECHANICAL
ME-00050
ME-00047