Subaru IMPREZA GD 2007 Series Manual page 2441

asieps_tobira_IM_US.book 40 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MECHANICAL
8) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
9) Remove the ST from the torque converter clutch
case. (AT model)
NOTE:
Be careful not to drop the ST into the torque con-
verter clutch case when removing the ST.
ST 498277200 STOPPER SET
10) Install the starter. <Ref. to SC(H4SO)-8, IN-
STALLATION, Starter.>
11) Install the torque converter clutch to drive plate.
(AT model)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the crank-
shaft using socket wrench.
NOTE:
Be careful not to drop bolts into the torque convert-
er clutch housing.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
(3) Install the service hole plug.
Engine Assembly
12) Install the power steering pump.
(1) Install the reservoir tank to the bracket.
T1
(2) Install the power steering pump. <Ref. to
PS-60, INSTALLATION, Oil Pump.>
MT-00085
(3) Install the power steering pipes onto the fuel
pipe protector RH.
(4) Install the front V-belt and adjust it. <Ref. to
ME(H4DOTC)-44, FRONT SIDE BELT, IN-
STALLATION, V-belt.>
13) Lift up the vehicle.
ME-00044
ME(H4DOTC)-40
FU-02572
ME-00037
ME-00036