Subaru IMPREZA GD 2007 Series Manual page 2449

asieps_tobira_IM_US.book 48 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MECHANICAL
15.Timing Belt
A: REMOVAL
1. TIMING BELT
NOTE:
Perform the work with the engine installed to body
when replacing a single part. For operation proce-
dures, refer to "Timing Belt" in the PM section.
<Ref. to PM-12, Timing Belt.>
1) Remove the V-belts. <Ref. to ME(H4DOTC)-44,
REMOVAL, V-belt.>
2) Remove the crank
ME(H4DOTC)-46, REMOVAL, Crank Pulley.>
3) Remove the timing belt cover. <Ref. to
ME(H4DOTC)-47, REMOVAL, Timing Belt Cover.>
4) Remove the timing belt guide. (MT model)
Timing Belt
5) If the alignment mark or arrow mark (which indi-
cates the direction of rotation) on timing belt fade
pulley. <Ref. to
away, put new marks before removing the timing
belt as shown in procedures below.
ST 499987500
ME-00065
ME-03124
ME-00728
ME(H4DOTC)-48
(1) Turn the crankshaft using ST, and align the
alignment marks on crank sprocket, intake cam
sprocket (LH), exhaust cam sprocket (LH), in-
take cam sprocket (RH) and exhaust cam
sprocket (RH) with notches of timing belt cover
and cylinder block.
CRANKSHAFT SOCKET
ST
ME-00729
ME-00069