Ip Vrf Forwarding - Dell S6000 Reference Manual

ip vrf forwarding

Enables you to attach an interface to a VRF.
Syntax
ip vrf forwarding {vrf-name | management}
To delete an interface associated with a configured VRF, use the no ip vrf
forwarding {vrf-name | management} command.
Parameters
vrf-name
management
Defaults None (Interface is part of default VRF).
Command INTERFACE-CONFIG
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 8.2.1.0
Version
Version
Version
Version
pre-Version
Usage
Use this command to attach an interface to a configured VRF. You can attach an
Information
interface to either a non-default VRF or a management VRF. To assign a port-back
to a default VRF, remove the interface associated with the VRF. You can use this
only if there is no IP address configured on the interface.
There must be no prior Layer 3 configuration on the interface when configuring
VRF.
VRF must be enabled prior to implementing this command.
You can configure an IP subnet or address on a physical or VLAN interface that
overlaps the same IP subnet or address configured on another interface only if the
Virtual Routing and Forwarding (VRF)
Enter the name of the VRF that you want to create.
Enter the name of the management VRF.
Introduced on the S-Series and Z-Series.
Introduced on the E-Series.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced support for telnetting to the VRRP group IP
address assigned using this command.
Introduced on the E-Series.
1449