Match Ip Vrf - Dell S4810 Reference Manual

Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related class-map
Commands

match ip vrf

Uses a VRF as the match criterion for an L3 class map.
S4810
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id
command.
Parameters
vlan vlan-id
Defaults none
Command CONF-CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related class-map
Commands
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S4810
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name
1354
— identifies the class map.
Enter the keyword vrf and then the ID of the VRF. The range
is from 1 to 63.
Introduced on the S-Series and Z-Series.
— identifies the class map.
Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Quality of Service (QoS)