Interface Types And Specifiers; Chapter 1 Command Reference Topics; Table 3: Interface Types And Specifiers For Erx7Xx Models, Erx14Xx Models - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

Related
Documentation

Interface Types and Specifiers

Table 3: Interface Types and Specifiers for ERX7xx Models, ERX14xx
Models, and ERX310 Router
Interface Type Description
atm ATM
interface or
ATM 1483
subinterface
Copyright © 2010, Juniper Networks, Inc.
ip route 10.10.0.166 255.255.255.255 192.168.1.1
ip debounce-time 0
router rip
For a list of regular expressions, see Using Regular Expressions in the JunosE IP Services
Configuration Guide
Many commands take the variables interfaceType and interfaceSpecifier. Some commands
support all types of interfaces, whereas other commands support only certain types of
interfaces. Similarly, some commands support all interface specifier formats for a
particular interface type, whereas other commands support only certain interface specifier
formats.
Table 3 on page 5 lists the interface specifiers for each type of interface on ERX7xx
models, ERX14xx models, and the Juniper Networks ERX310 Broadband Services Router.
NOTE: On ERX7xx models, ERX14xx models, and the ERX310 router, you can
use the atm slot/port/vpi/vci interface specifier format as an alternative to
the atm slot/port.subinterface format with the specific show interface and
show subinterface commands to monitor all ATM 1483 subinterfaces (except
NBMA interfaces) as well as the upper-layer interfaces configured over an
ATM 1483 subinterface. You cannot, however, use the atm slot/port/vpi/vci
format to create or modify an ATM 1483 subinterface.
Table 4 on page 13 lists the interface specifiers for each type of interface on the Juniper
Networks E120 and E320 Broadband Services Routers.
NOTE: On the E120 router and the E320 router you can use the atm
slot/adapter/port/vpi/vci interface specifier format as an alternative to the
atm slot/adapter/port.subinterface format with the specific show interface
and show subinterface commands to monitor all ATM 1483 subinterfaces
(except NBMA interfaces) as well as the upper-layer interfaces configured
over an ATM 1483 subinterface. You cannot, however, use the atm
slot/adapter/port/vpi/vci format to create or modify an ATM 1483
subinterface.
Interface Specifier
Refer to the individual formats listed below.
Chapter 1: Command Reference Topics
Example
5