Installing Movable Mechanical Stops On Axis 1 (Option 3323-1) - ABB IRB 6710 Product Manual

3 Installation and commissioning

3.4.2 Installing movable mechanical stops on axis 1 (option 3323-1)

3.4.2 Installing movable mechanical stops on axis 1 (option 3323-1)
Reduction of the axis-1 working range
The working range of axis 1 is limited by system parameter configuration. To reduce
the working range from default range, first adjust the parameter values and then
install additional mechanical stops as a safety measure.
The movable mechanical stops reduce the working range according to the table.
Graduation of limited working range
15°
Illustration, reduced working range
xx2100000973
Continues on next page
86
WARNING
If the mechanical stop pin is deformed after a hard collision, it must be replaced!
Deformed movable stops and/or additional stops as well as deformed attachment
screws must also be replaced after a hard collision.
© Copyright 2023 ABB. All rights reserved.
Reduction of working range
from ±5° and ±125° in both directions
A
A
Product manual - IRB 6710
3HAC085695-001 Revision: A