ABB IRB 6710 Product Manual page 220

5 Repair
5.3.3 Replacing the rear bearings on the balancing device
Continued
Spare part
Maintenance set, cradle
Required tools and equipment
Equipment
Lock screw, M16x120
Hydraulic press equipment, balan-
cing device
Dismantle and mounting tool
Hydraulic pump 80 MPa
Hydraulic cylinder
Lifting shackle
Lifting accessory (chain)
Standard toolkit
Required service parts
Equipment
VK cover, 100x10
Locking liquid
Grease
Continues on next page
220
Article number
3HAC087164-001
Article number
-
3HAC074411-001
3HAC028920-001
3HAC13086-1
3HAC11731-1
-
3HAC15556-1
-
Article number
3HAA2166-13
-
3HAC042536-001
© Copyright 2023 ABB. All rights reserved.
Note
The maintenance set contains:
• radial sealing with dust lip,
2 pcs
• groove ball bearing com-
plete, 2 pcs
• retaining ring, bore, 2 pcs
• VK-cover, 2 pcs
(3HAA2166-13)
Note
Used to secure lower arm.
Used to unload or restore a balan-
cing device.
User instructions are enclosed
with the tool.
Used for removing and fitting
shaft and bearings.
User instructions are enclosed
with the tool.
To be used with the press and
puller tools.
See technical specifications in the
user instructions for the press
equipment.
To be used with the press and
puller tools.
See technical specifications in the
user instructions for the press
equipment.
SA-10-8-NA1
Lifting instruction 3HAC15880-2
enclosed.
Content is defined in section
Standard toolkit on page
Note
Located at the cradle of the balancing
device. 2 pcs required.
Replace if damaged.
Loctite 2400 (or equivalent Loctite 243)
Shell Gadus S2
Product manual - IRB 6710
3HAC085695-001 Revision: A
628.