ABB IRB 6710 Product Manual page 63

Slings attached directly onto robot
This section details how to lift and move the robot using lifting slings when these
are attached directly onto the robot.
1
2
3
4
5
6
Product manual - IRB 6710
3HAC085695-001 Revision: A
3.3.3.1 Lifting robot with lifting accessory (recommended lifting method)
Note
Please refer to the enclosed user instruction for instruction how to place the
manipulator in an correct position. Attempting to lift a manipulator in any other
position may result in the robot tipping over, causing severe damage or injury!
Action
Run the overhead crane to a position above
the robot.
Position the robot as detailed in enclosed in-
struction!
Fit the lifting accessory to the robot as de-
scribed in the enclosed instruction!
Go to the user instructions enclosed with the
lifting accessory.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions
for the tool.
CAUTION
The IRB 6710 robot weighs .
IRB 6710-210/2.65: 1,140 kg
IRB 6710-200/2.95: 1,150 kg
IRB 6710-175/2.65 LID: 1,200 kg
IRB 6710-175/2.95 LID: 1,210 kg
All lifting accessories used must be sized ac-
cordingly!
WARNING
Personnel must not, under any circumstances,
be present under the suspended load!
Raise overhead crane to lift the robot.
© Copyright 2023 ABB. All rights reserved.
3 Installation and commissioning
Note
Article number is specified in
equipment on page
Release the brakes, if required, as de-
tailed in section Manually releasing the
brakes on page 72.
Article number is specified in
equipment on page
Make sure all hooks and attachments
maintain their correct positions while
lifting the robot!
Always move the robot at very low
speeds, making sure it does not tip.
Continued
Required
62.
Required
62.
63