Checking The Synchronization Position - ABB IRB 6710 Product Manual

6 Calibration

6.6 Checking the synchronization position

6.6 Checking the synchronization position
Introduction
Check the synchronization position of the robot before beginning any programming
of the robot system. This may be done:
Using a MoveAbsJ instruction
Use this procedure to create a program that runs all the robot axes to their
synchronization position.
1
2
3
4
5
6
Using the jogging window
Use this procedure to jog the robot to the synchronization position of all axes.
1
2
3
4
5
6
608
• Using a MoveAbsJ instruction with argument zero on all axes.
• Using the Jog window on the FlexPendant.
Action
Tap Code.
Create a new program.
Use MoveAbsJ in the Add Instruction menu.
Create the following program:
MoveAbsJ [[0,0,0,0,0,0],
[9E9,9E9,9E9,9E9,9E9,9E9]]
\NoEOffs, v1000, fine, tool0
Run the program in manual mode.
Check that the synchronization marks for the axes
align correctly. If they do not, update the revolu-
tion counters.
Action
Tap Jog.
From the Mechanical unit list select a
mechanical unit.
From the Motion mode section, select an
axis-set that need to be jogged.
For example, to jog axis 2, select the axis
set Axis 1-3.
Follow the screen instruction on joystick
movements to understand the direction of
the axis that you want to move and move
the joystick.
Manually run the robots axes to a position
where the axis position value read on the
FlexPendant, is equal to zero.
Check that the synchronization marks for
the axes align correctly. If they do not, up-
date the revolution counters.
© Copyright 2023 ABB. All rights reserved.
Note
See Synchronization marks and
synchronization position for axes on
page 589 and Updating revolution
counters on page 592.
Note
See Synchronization marks and synchron-
ization position for axes on page 589
Updating revolution counters on page
Product manual - IRB 6710
3HAC085695-001 Revision: A
and
592.