ABB IRB 6710 Product Manual page 388

5 Repair
5.7.3 Replacing the axis-3 motor
Continued
6
7
8
9
10
11
Connecting the motor cables
1
Continues on next page
388
Action
Apply the rotation tool.
Use caution and fit the motor in its final
position while at the same time rotating the
motor pinion slightly using the rotation tool.
• Make sure that the motor pinion is
properly mated to the gear of the
gearbox.
• Make sure that the motor pinion
does not get damaged.
• Make sure that the direction of the
cable exit is facing the correct way.
Fit two of the attachment screws and
washers.
Use a bits extender in order to reach the
screws.
Remove the guide pins and replace with
the remaining attachment screws.
Tighten the screws.
Disconnect the brake release tool.
Perform a leak-down test.
Action
Put the motor cables in place in the open-
ing.
© Copyright 2023 ABB. All rights reserved.
Note
Rotation tool M4: 3HAB7887-1
Hex socket head cap screw: M10x30 12.9
Gleitmo 603+Geomet 500 (2 pcs)
Bits extender: 3HAC12342-1
xx2100002152
Hex socket head cap screw: M10x30 12.9
Gleitmo 603+Geomet 500 (2 pcs)
xx2100002153
Tightening torque: 50 Nm.
See Performing a leak-down test on
page 178.
Note
Product manual - IRB 6710
3HAC085695-001 Revision: A