ABB IRB 6710 Product Manual page 521

3
4
5
Product manual - IRB 6710
3HAC085695-001 Revision: A
Action
Jog the robot into position:
• Axis 1: no significance
• Axis 2: -65°
• Axis 3: maximum position in positive
direction, upper arm resting against
the mechanical stop (approximately
+70°)
• Axis 4: 0°
• Axis 5: +90°
• Axis 6: 0°
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the safe-
guarded space.
If robot is equipped with DressPack:
Unscrew the uppermost attachment screw
that holds the bracket of the DressPack
cable package, and let it "fall down". See
figure!
Note
It is not needed to disconnect the lower
end connectors of the DressPack (as the
figure shows). Connectors are only hidden
to get a better view of which screw to be
removed.
© Copyright 2023 ABB. All rights reserved.
5.8.3 Replacing the axis-3 gearbox
Note
If needed, run the axis-1 into a position that
gives the required space (space to place
two pallets in a row) at the right-hand side
of the robot, as seen from behind.
xx2200001811
xx1200001331
A Attachment screw to be removed
B Attachment screw not to be removed
Continues on next page
5 Repair
Continued
521