ABB IRB 6710 Product Manual page 549

Refitting the cable harness to the upper arm
1
2
Product manual - IRB 6710
3HAC085695-001 Revision: A
Action
Refit the metal clamp beneath the arm
house.
Tip
Use tape and tie the axis-5 and axis-6
connectors and carrier into a bundle (if not
already done). This is done to facilitate the
procedure and to avoid damaging the parts
during the procedure.
This will also make it easier to run the cable
harness through the inside of the robot.
© Copyright 2023 ABB. All rights reserved.
5.8.3 Replacing the axis-3 gearbox
Note
Torx pan head screw: M6x16 A4-80
Tightening torque: 10 Nm.
xx2200002142
xx1300000668
Continues on next page
5 Repair
Continued
549