ABB IRB 6710 Product Manual page 254

5 Repair
5.4.1 Replacing the arm house cover including the axis-4 cassette sealing
Continued
2
3
4
Continues on next page
254
Action
Push the cable harness into the wrist re-
cess and up into the axis-6 motor.
Tip
Moisten the rubber carrier slightly with
water or grease around the contact surface,
to make it easier to fit into place.
Push the carrier carefully into position.
Secure the carrier with the M4x10 screw.
Note
The screw is located at the bottom of the
carrier.
Tip
The attachment screw securing the carrier
may be difficult to fit. Make sure the carrier
is level and completely pressed against the
bottom.
© Copyright 2023 ABB. All rights reserved.
Note
xx1300000667
xx1300001113
xx1300000485
Product manual - IRB 6710
3HAC085695-001 Revision: A