ABB IRB 6710 Product Manual page 227

4
5
6
7
Product manual - IRB 6710
3HAC085695-001 Revision: A
5.3.3 Replacing the rear bearings on the balancing device
Action
Apply a threaded bar into the hole in the
balancing device and use the dismantle
and mounting tool, according to user in-
structions enclosed with the equipment.
xx0900000813
Go to the user instructions enclosed with
the press tool.
DANGER
Handling the tool incorrectly will cause
serious injury.
Read and follow enclosed user instructions
for the tool.
Fit the retaining ring bore.
Apply locking liquid on the attachment
screw.
While using the screw driver between the
cradle and balancing device as a distance
tool, tighten the attachment screw com-
pletely.
Secure the balancing device.
© Copyright 2023 ABB. All rights reserved.
Note
Dismantle and mounting tool:
3HAC028920-001
User instructions are enclosed with the
tool.
xx2300000006
Hex socket head cap screw: M16x70 12.9
Gleitmo 603+Geomet 500
Washer: 3HAC047681-001
Locking liquid: Loctite 2400 (or equivalent
Loctite 243)
Tightening torque: 280 Nm.
xx2200001475
Continues on next page
5 Repair
Continued
227