GE Senographe DS Manual page 768

GE Healthcare
Revision 1
Job Card ELE A050 - Changing Senographe Internal IP Addresses
30. Reboot the system for the changes to take effect by entering:
reboot
31. From the Browser, launch the Service Desktop (see
and ensure that the Service Desktop is working as expected.
32. Shut down and power up the entire Senographe system.
33. After the reboot has completed, an S61 X-ray Beam not ready error message may appear on the X-
ray Console. This occurs because the Gantry CPU has to boot up after the ADS computer. To
restore communication between the Gantry CPU and the ADS computer, on the X-ray Console press
the O (off) button and then press the I (on) button.
7-7 Copy Backup Files from the IPbak Directory to Floppy Disk or CD-R
Copy the backup files you made in /export/home/extra_tmp/IPbak to either floppy diskette or CD-R by
following the steps in the appropriate section.
Note:
No floppy disk drive exists on the V3/V4 Control Station, so you must use the CD-R media on V3/
V4 Control Stations.
7-7-1 Copying Backup Files to Floppy Disk
To copy the backup files to floppy disk, proceed as follows:
1. From behind the Browser, launch a command window (see
page 120).
2. Insert a blank DOS formatted floppy diskette in AWS floppy disk drive.
3. Log in as root as follows:
a. At the ADS prompt enter:
su -
b. When requested to specify the root password, enter:
operator
4. Mount the floppy disk drive to /floppy, by entering:
mount -f pcfs /dev/fd0 /floppy
5. Make an IPbak directory on the floppy disk, by entering:
mkdir /floppy/IPbak
6. Copy the entire contents of the /export/home/extra_tmp/IPbak directory, by entering:
cp /export/home/extra_tmp/IPbak/* /floppy/IPbak
7. Logout as the root user, by entering:
exit
You are returned to the command prompt as the sdc user.
8. Unmount the floppy disk drive, by entering:
umount /floppy
9. Eject the floppy diskette which contains all of the original backed up files, by entering:
eject
Chapter 7
Service Information and Procedures Class A 2385072-16-8EN
Launching the Service Desktop on page
Launching a Command Line Window on
Page no. 768
Senographe DS
120),
JC-ELE-A-050.fm