GE Senographe DS Manual page 773

GE Healthcare
Revision 1
It is possible to carry out a restore procedure in the following ways:
• AWS configuration data can be restored from floppy diskette Backup 1 or Backup 2.
• IDC configuration data can be restored from the AWS disk file Backup 1 or Backup 2.
• Senographe data can be restored from the AWS disk file Backup 1 or Backup 2.
! Notice:
1. A system backup is recommended after each change of configuration of any part of the system,
and after each set of calibrations.
2. A system backup is not recommended after a single calibration or configuration change when
the change is going to be followed by more changes.
3. Each time that a system backup is made, the current AWS file backup Backup 2 is lost (over-
written by Backup 1). This must be taken into account when considering a new backup.
4. Medical Preferences are not saved. They must be noted manually for reinstallation.
7 BACKUP PROCEDURES
The backup procedures vary according to the type of Control Station in the system.
• Refer to section 7-1,
Stations.
• Refer to section 7-2,
Stations.
JC-ELE-A-052.fm
Service Information and Procedures Class A 2385072-16-8EN
Backup Procedure on V1/V2 Control Stations on page 774
Backup Procedure on V3/V4 Control Stations on page 775
Job Card ELE A052 - Back-up/Restore Procedure
Page no. 773
Senographe DS
for V1/V2 Control
for V3/V4 Control
Chapter 7