GE Senographe DS Manual page 1042

GE Healthcare
Revision 1
Job Card TSG A015 - Lift Movement Troubleshooting
2 TROUBLESHOOTING STEERING GUIDE
The troubleshooting steering guide to use depends on the type of Lift Screw Assembly installed in the
system. Determine the type of Lift Screw Assembly that is installed in the system according to
2, Lift Type Identification and Related FRU Compatibility Matrix on page
lowing three sub-sections according to the Type of Lift Screw Assembly installed in the Gantry:
2-1 Trouble Shooting Steering Guide For Type 1 Lift Screw Assembly
Use the following flow charts (illustration 2 and illustration 3) to isolate the issue causing the Lift move-
ment problems on systems with a Type 1 Lift Screw Assembly.
ILLUSTRATION 2 - LIFT TROUBLESHOOTING ENTRY - TYPE 1 LIFT SCREW ASSEMBLY
Does customer complain about
Error 102/024 or does Error 102/024 repeatly
Install Type 3 Lift Screw Assembly with Brake Motor (5337148)
See Job Card D/R A232 - Lift Screw Assembly on page 1255
Note: The brake functionality requires the old system to have
2373567-8 Lift Board and Lift CPLD version 10.0.1 or above. Check
the Service Desktop home page and if the Lift Board CPLD version
is less than 10.0.1 you must also change the Lift Board according to
Job Card D/R A201 - Lift Board on page
Perform Lift Functional Checks.
See
Checks on page
checks, return back here.
Lift Gas Spring Checks
See
Checks on page
Change Lift Gas Spring
See
Gas Spring on page
Perform Lift Functional Checks.
See
Checks on page
Chapter 9
appear in the error logs?
Yes
section 3-1 , Lift Functional
1048. After the
NOK
section 3-4 , Lift Gas Spring
1052.
NOK
Job Card D/R A206A - Lift
1183.
section 3-1 , Lift Functional
1048.
NOK
Contact OLC.
Service Information and Procedures Class A 2385072-16-8EN
No
1161.
OK
OK
OK
OK
OK
OK
Page no. 1042
1036. Then use one of the fol-
Perform the lift trouble shooting steps described
in illustration 3, Troubleshooting Flowchart For
Lift Movement Problems Related to Errors 102/
013 and 102/014 - Type 1 Lift Screw Assembly
on page 1043
Senographe DS
section 1-
JC-TSG-A-015.fm