GE Senographe DS Manual page 637

GE Healthcare
Revision 1
nge0 option, and press the <F2> key to continue.
Set the Default Route for nge0
To specify the default route, you can let the software ...
.........................
10. At the Confirmation Information for nge0 screen, ensure that the correct information appears for the
nge0 network interface, and press the <F2> key to continue.
Confirm information for nge0
> Confirm the following information. If it is correct ...
.........................
System part of a subnet: Yes
A screen indicating a delay may appear while the settings for the nge0 network interface are being
stored.
11. At the Configure Security Policy screen, ensure that No is selected for the Configure Kerberos Secu-
JC-ELE-A-021.fm
Default Route for nge0
--------------------
Detect one upon reboot
Specify one
X
X
None
Networked:
Use DHCP: No
Host name: XXXXXX
IP address: N.N.N.N
Netmask: N.N.N.N
Enable IPv6: No
Default Route: None
Just a moment
Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A021 - Networking Connection and Configuration
Yes
Page no. 637
Senographe DS
Chapter 7