GE Senographe DS Manual page 695

GE Healthcare
Revision 1
7-2-3 Review Final AOP Settings
1. Review the Local Recommendations on page 694
apply. Ensure that the customer obeys any local constraints that may apply to them.
2. Note down the decided configuration in Table 3.
TABLE 3 - AOP CONFIGURATION
AOP Mode Configured Component
STD
DOSE
CNT
7-3 Decision Tree
• At the very first installation:
- If you decide to keep the factory settings, go directly to
- If you decide the AOP settings are different from the factory settings, follow the steps summarized
in illustration 1.
• At a later date after the very first installation:
- If you decide to change the current AOP settings, follow the steps summarized in illustration 1.
- If the AOP settings were not kept due to performing a DR Job Card or update on the Generator
CPU Board or ADS Computer, review the customer's last known AOP configuration in Table 3
and follow the steps summarized in illustration 1 to restore them.
JC-ELE-A-031.fm
Site:
Date:
Generator
ADS Computer
Generator
Generator
Service Information and Procedures Class A 2385072-16-8EN
above to determine which AOP Configuration to
Very first Reconfigura-
installation tion
1
Setting Setting
Completion on page
Page no. 695
Job Card ELE A031 - AOP Configuration
Reconfigura-
tion
2 2
Setting
698.
Senographe DS
Reconfigura-
tion
3
Setting
Chapter 7