GE Senographe DS Manual page 654

GE Healthcare
Revision 1
Job Card ELE A021 - Networking Connection and Configuration
10. Make the /etc/rc2.d/S93route file non-writable by entering:
chmod o-w /etc/rc2.d/S93route
11. Reboot the system for the changes to take effect by entering:
reboot
9 CHANGE AUTO NEGOTIATION OF NETWORK INTERFACE
The workstation SunBlade 150 computer on V1/V2 Control Stations uses a network interface on the
motherboard which is called "eri". By default the eri interface is configured for: auto negotiation = yes,
and a maximum speed up to 100 Mbit/s full duplex negotiated by the workstation.
The workstation U20 computer on V3 Control Stations uses a network interface on the motherboard
which is called "nge0". By default the nge0 interface is configured for: auto negotiation = yes, and a max-
imum speed up to 1000 Mbit/s full duplex negotiated by the workstation.
The workstation Z400 computer on V4 Control Stations uses a network interface on the motherboard
which is called "e1000g0". By default the e1000g0 interface is configured for: auto negotiation = yes, and
a maximum speed up to 1000 Mbit/s full duplex negotiated by the workstation.
9-1 Querying the Current Network Interface Settings
You can read the current settings of the Network Interface at any time by using the following steps:
1. Log in as root as follows:
a. At the ADS prompt enter:
su -
b. When requested to specify the root password, enter:
operator
2. Get the current auto negotiation mode settings as follows:
For V1/V2 Control Stations, enter:
ndd -get /dev/eri adv_autoneg_cap
For V3 Control Stations, enter:
ndd -get /dev/nge0 adv_autoneg_cap
For V4 Control Stations, enter:
ndd -get /dev/e1000g0 adv_autoneg_cap
If the system is running in auto negotiation mode the command line responds with the value 1. If the
system is not running in auto negotiation mode the command line responds with the value 0.
Chapter 7
Service Information and Procedures Class A 2385072-16-8EN
Page no. 654
Senographe DS
JC-ELE-A-021.fm