GE Healthcare
Revision 1
5. Release the two screws securing the Upper Optical Fork (3) (2.5 mm allen wrench).
6-2
Reassembly of the Upper Optical Fork
1. Use the two screws to secure the new Upper Optical Fork (1) (2.5 mm allen wrench) to the Gantry
frame.
2. Route the Upper Optical Fork cable (W201) down the Gantry framework past the position of the lower
Optical Fork. Then use the two screws to secure the original Lower Optical Fork back into place (2.5
mm allen wrench).
3. Connect the Upper Optical Fork cable (2) labeled J4/PL201 - W201 from the new Upper Optical Fork
JC-DR-A-202.fm
Service Information and Procedures Class A 2385072-16-8EN
3
1
Page no. 1169
Job Card D/R A202 - Upper Optical Fork
Senographe DS
Chapter 9