Subaru IMPREZA GD 2007 Series Manual page 3537

asieps_tobira_IM_US.book 14 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AIRBAG SYSTEM
5. Passenger's Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
3, CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the glove box. <Ref. to EI-43, REMOV-
AL, Glove Box.>
4) Detach the airbag connector from support beam
bracket, and then disconnect the airbag connector.
5) Remove the three bolts, and then carefully re-
move the passenger's airbag module.
6) Refer to "CAUTION" for handling of a removed
airbag module. <Ref. to AB-3, CAUTION, General
Description.>
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Do not allow harness and connectors to inter-
fere or get tangled up with other parts.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to AB-2, SRS AIRBAG, COMPO-
NENT, General Description.>
C: INSPECTION
CAUTION:
Refer to "CAUTION" of "General Description"
before handling the airbag module. <Ref. to AB-
3, CAUTION, General Description.>
Check for the following, and replace the damaged
parts with new parts.
• Airbag module, harness, connector and mount-
ing bracket are damaged. <Ref. to AB-10, PAS-
SENGER'S AIRBAG MODULE, INSPECTION,
Inspection Locations After a Collision.>
Passenger's Airbag Module
AB-00492
AB-14