Subaru IMPREZA GD 2007 Series Manual page 3528

asieps_tobira_IM_US.book 5 ページ ２０１２年１月１７日 火曜日 午後３時４８分
• When painting or performing sheet metal work
on the side of the vehicle, including the side sill,
center pillar and front and rear doors, remove the
side airbag sensors and wiring harness of the air-
bag system.
N N N N N N N N N N N N G G G G G G G G G N N G NG G G G G G G NG G NG N N N N G G N NG
• Do not discard undeployed airbag module or pre-
tensioner.
• After removing all the parts of airbag system,
keep the airbag module with the pad side facing up-
ward on a dry, clean and flat surface away from
heat, light sources, moisture and dust.
• When airbag control module, front sub sensor
and side airbag sensor are removed, do not reuse
the bolts and nuts. Always use new bolts and nuts
for them.
General Description
G G G G G
AB-01542
AB-00056
AB-5
AIRBAG SYSTEM