asieps_tobira_IM_US.book 7 ページ 2012年1月17日 火曜日 午後3時48分
Wheel Balancing
WHEEL AND TIRE SYSTEM
4) Select the closest weight to the calculated value,
degrease the adhesive surface designated by the
balancer, and apply that weight.
CAUTION:
• Press the adhesive part by 25 N·m (2.6 kgf-m,
18 ft-lb) or more per 5 g (0.18 oz) for two sec-
onds or more to attain full adhesion.
• Perform the balance adjustment on outer
side first, then on inner side.
• Total application of the weight should be 100
g (3.53 oz) or less.
B: INSPECTION
1) If the tire has been repaired or worn, correct
wheel balance may be lost. Check the tire dynamic
balance and repair if necessary.
2) Use the dynamic balancer to check dynamic bal-
ance. Drive with balance weights applied to both
upper and rear side of the rim.
3) Some kinds of balancer may damage the wheel.
Use an appropriate balancer when adjusting wheel
balance.
4) Use Subaru genuine balance weights.
A
WT-00111
Service limit A:
5.0 mm (0.20 in)
WT-7