Table of Contents
Advertisement
Debug Resources
Programming – Control and Address Pointer Registers
Each watchpoint has two address registers—
point Address Pointers – WP0L, WP1L, WP2L, WP0H, WP1H and
WP2H" on page 2-29 for more information. When the watchpoint is pro-
grammed for a single address, only the low address register (
If the watchpoint is searching for an address range, the
address, and the
contained within a single internal memory block or within the external
memory space. The only exception is watchpoint 0 when it is programmed
to search for the sequencer instruction fetch. In this case, the range is
unlimited. When the address range is external, the DMA external accesses
are not monitored.
COUNTER
Figure 9-1. WPxCTL (Upper) Register Bit Descriptions
9-4
holds the high address. The address range must be
WPiH
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
and
WPiL
ADSP-TS101 TigerSHARC Processor
Hardware Reference
. See "Watch-
WPiH
) is used.
WPiL
holds the low
WPiL
Advertisement
Table of Contents
