Description (Acl Vlan Group) - Dell C9000 Series Reference Manual

Default To reset the number FP blocks allocated for ACL VLAN processes, enter the default
keyword with the cam-acl-vlan command. By default, 0 FP blocks are allocated for
ACL VLAN operations on the switch.
Command Modes
ACL-VLAN-GROUP CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
Version
9.10(0.0)
9.9(0.0)
9.5(0.1)
9.3(0.0)
Usage Information The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that
modifies the VLAN settings before packets are forwarded. To support the ACL CAM
optimization functionality, the CAM carving feature is enhanced. A total of four VACP
groups are present, of which two are for fixed groups and the other two are for
dynamic groups. Out of the total of two dynamic groups, you can allocate zero, one, or
two flow processor (FP) blocks to iSCSI counters, Open Flow and ACL VLAN
optimization. You can configure CAM FP blocks for only two of these ACL VLAN
services at a time. Use this command in Configuration Terminal Batch mode to
configure in a dual-homing setup.

description (ACL VLAN Group)

Add a text description of an ACL VLAN group.
C9000 Series
Syntax
description text
Parameters
description
Default No default behavior or values
Command Modes ACL-VLAN-GROUP CONFIGURATION (conf-acl-vl-grp)
Command History
Version
9.9(0.0)
9.5(0.0)
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
Enter a text to identify the ACL VLAN group (80 characters
maximum).
Description
Introduced on the C9010.
Introduced on the Z9500.
Access Control Lists (ACL) 322