Avaya DEFINITY Server CSI Maintenance Manual page 649

ANL-24-L (24-Port Analog Line)
Station Status and Translation Audits and
Updates Test (#36)
This test updates the analog port's message lamp state (if it has one) and
translations with information in the software.
Table 41. Test #36 Station Status and Translation Audits and Updates
Error Test
Code Result
ABORT
1004 ABORT
1005 ABORT
1006 ABORT
2000 ABORT
2100 ABORT
1 FAIL
555-233-119
Description/ Recommendation
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
The port was seized by a valid call during the test. The test has been
aborted.
1. Use display port PCSSpp to determine the station extension.
2. Use status station to determine the service state of the port.
3. If the port is in use, wait until port is idle and retry the command at
1-minute intervals a maximum of 5 times.
The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
This port has been busied out by command, or taken out-of-service by the
failure of the NPE Crosstalk Test.
1. Look in the Error Log for error type 18 (port busied out) for this port. If
this error is present, use release station extension to release the port,
and run the test again.
2. Check the Error Log for error type 1025 (NPE crosstalk test failed) for
this port. If this error is present, investigate the errors associated with
the NPE Crosstalk Test #6.
3. Make sure that the terminal is connected and in service and retest.
Response to the test request was not received within the allowable time
period.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
This does not indicate a hardware problem. The switchhook audit failed. The
other updates were not performed because of this failure. This may occur
when the audit is performed at the same time the terminal equipment goes
off-hook.
1. Use status station to determine when the port is available and retry the
command at 1-minute intervals a maximum of 5 times.
Continued on next page
Issue 5 October 2002
649