Adx16D-P (16-Port Audix Digital Port) - Avaya DEFINITY Server CSI Maintenance Manual

ADX16D-P (16-Port AUDIX Digital Port)

ADX16D-P (16-Port AUDIX Digital
Port)
MO Name (in
Alarm Log)
ADX16D-P MINOR or WARNINGS
1. Where P is the port network number (1 for PPN); C is the carrier designation (for example, A, B,
or C); SS is the address of the slot in the carrier where the circuit pack is located (for example, 01,
02, etc.); and pp is the 2-digit port number (for example, 01).
!
CAUTION:
Never do any of the following without first shutting down AUDIX. Follow
instructions in the
''Maintenance for CSI
The ADX16D-P maintenance object represents a port on a TN566/TN2169
EMBEDDED AUDIX circuit pack operating in digital-port (DP) mode. The
maintenance strategy for ports on the TN566 operating in control-link mode is
described in ADX16A-PT.
The tests described in this section apply only to switch-side maintenance which
tests circuit pack components related to the TDM bus interface. The AUDIX
system has an extensive maintenance strategy that is described in EMBEDDED
AUDIX System Maintenance, 585-300-110.
AUDIX resides on a combined pair of circuit packs: the TN566 Multifunction Board
(MFB) and the TN2169 Alarm Board (ALB). Because of its size this combination
occupies 5 slots, but only 1 slot is functional as far as the system is concerned.
The other 4 slots are seen by the switch as ''AUDIX-reserved'' slots (or
ADX16-RES/ADX16D-RS).
In 16 Port DP mode, the TN566 pack supports up to 16 voice ports, each with a
primary information channel and a secondary information channel. Ports are
administered in increments of two. When a call to a station with an AUDIX login is
not answered, AUDIX answers the call using one of the available voice ports.
Unlike other AUDIX systems, EMBEDDED AUDIX is not an adjunct.
555-233-119
Alarm Level Initial Command To Run
test port PCSSpp l
''Power Down AUDIX System''
systems''.
1
Full Name of MO
AUDIX Digital Port
section in Chapter 1,
Issue 5 October 2002
623