Avaya DEFINITY Server CSI Maintenance Manual page 661

ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon
Analog Line)
Table 45. TEST #6 NPE Crosstalk Test — Continued
Error Test
Code Result
1005 ABORT
1018 ABORT
1020 ABORT
2000 ABORT
2100 ABORT
555-233-119
Description/ Recommendation
The test was aborted due to a configuration problem. This code will result
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13, 14 and 15
— TN769 vintages 3, 4 and 5
The test has been disabled via administration. The default for the
field on the Station screen is y. Determine why this field has been set to
for this station. It may be due to application Test #48, which can disturb
users or terminal operations.
1. To enable the test for the station being tested, enter change station
extension and set the
The test did not run due to a previously existing error on the specific port or
a more general circuit pack error.
1. Examine Error Log for existing errors against this port or the circuit
pack and attempt to diagnose the previously existing error.
Response to the test request was not received within the allowable time
period.
System resources required to run this test are not available. Either a
system allocation to get information about the port or to put the port into a
service state failed or the attempt to put the port in connection with a tone
source failed (this could be a tone-clock problem). The tone-clock and tone
detectors could be having a communication problem, for example, the
companding modes could be out of synchronization.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Test field to y.
Continued on next page
Issue 5 October 2002
Test
n
661