Test Customer-Alarm - Avaya DEFINITY Server CSI Maintenance Manual

Maintenance Commands

test customer-alarm

Use test customer-alarm to run hardware diagnostic tests on the leads of the
Processor and EPN maintenance circuit packs, used for customer-provided
alarms by closing the appropriate relay for 1 minute. Failure is verified by
checking the customer alarm attached to the specified circuit pack.
Action/Object Qualifier
test customer- location
alarm
short
long
repeat
number
clear
schedule
1 If no alarms are registered against the maintenance object then the test sequence is run only once. The long
clear option forces a clear of all alarms if no errors are encountered during testing. The short clear option only
clears alarms pertinent to tests in the short sequence.
2 See the Report Scheduler and System Printer feature specification for more details.
542
Issue 5 October 2002
Qualifier Description
Extension of the data module or
data channel to be tested (per
dial-plan)
Runs test number 115
Runs test number 115 (same as
short test option)s
How many times each test in the
sequence is repeated (1-100)
This option causes the test
sequence (short or long) to repeat
until the alarm (if any) is cleared or
a single test in the sequence fails.
Use the screen to schedule
execution of the command. The
command is placed in the
command queue and is executed
at the specified time. The
information displayed by the
command is sent to the system
printer instead of the screen.
Examples:
test customer-alarm
test customer-alarm schedule
test customer-alarm 02 r 2
test customer-alarm 01b r 25
test customer-alarm 01b r 25
schedule
test customer-alarm 2a
test customer-alarm 2a sh
test customer-alarm 01b l
schedule
test customer-alarm 3 c
Logins Defaults
init cabinet =1
inads
carrier = a
craft
repeat = 1
1
2
Feature
Interactions
none
555-233-119