[Sysname-acl-basic-2000] rule deny source any
[Sysname-acl-basic-2000] quit
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] pim neighbor-policy 2000
pim sm
Syntax
pim sm
undo pim sm
View
Interface view
Parameters
None
Description
Use the pim sm command to enable PIM-SM on the current interface.
Use the undo pim sm command to disable PIM-SM on the current interface.
By default, PIM-SM is disabled.
Typically, PIM-SM should be enabled on all interfaces.
Before enabling PIM-SM, you must enable multicast routing first.
Related commands: multicast routing-enable.
Examples
# Enable the PIM-SM protocol on VLAN-interface 10.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] multicast routing-enable
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] pim sm
pim timer hello
Syntax
pim timer hello seconds
undo pim timer hello
View
Interface view
Parameters
seconds: PIM Hello interval in seconds, namely the interval between PIM Hello messages, in the range
of 1 to 18,000.
3-13