Pim-Dm Configuration; Pim-Sm Configuration - 3Com 7757 Configuration Manual

472 C 47: PIM C
HAPTER

PIM-DM Configuration

Configuring Filtering
Policies for Multicast
Source/Group

PIM-SM Configuration

Configuring Filtering
Policies for Multicast
Source/Group
Configuring BSR/RP
ONFIGURATION
Perform the following configuration to configure PIM-DM. When the router runs
in PIM-DM domain, you are recommended to enable PIM-DM on all the interfaces
of non-boarder routers.
Table 377 Configure filtering policies for multicast source/group
Operation
Enter system view
Enable the multicast routing
protocol
Enter PIM view
Perform source/group filter on
the received multicast packets
c
CAUTION:
If you configure basic ACLs, the source address match is performed on all the
■
received multicast packets. The packets failing to match are discarded.
If you configure advanced ACLs, the source address and group address match
■
is performed on all the received multicast packets. The packets failing to match
are discarded.
PIM-SM configuration includes:
Table 378 Configuration tasks
Operation
Configure filtering policies for
multicast sources/groups
Configure BSR/RP
Configure PIM-SM domain
boundary
Filter the registration packets
from RP to DR
For the configuration of filtering policies for multicast source/group, refer to
"PIM-DM Configuration" on page 472.
Table 379 Configure BSR/RP
Operation
Enter system view
Enable the multicast routing
protocol
Enter PIM view
Command
system-view
multicast routing-enable
pim
source-policy acl-number
Description Section
Optional "Configuring Filtering Policies for Multicast
Source/Group" on page 472
Optional "Configuring BSR/RP" on page 472
Optional "Configuring PIM-SM Domain Boundary"
on page 474
Optional "Filtering the Registration Packets from RP
to DR" on page 474
Command
system-view
multicast routing-enable
pim
Description
-
Required
-
Optional
You can configure to filter the
IP addresses of some multicast
groups in ACL.
Description
-
Required
-