Honda Accord 2008 Manual page 723

07/11/02 09:19:57 61TA0000_110_0404
EVAP System
DTC Troubleshooting (cont'd)
15. Turn the ignition switch to LOCK (0).
16. Jump the SCS line with the HDS.
17. Disconnect ECM/PCM connector A (49P).
18. Connect FTP sensor 3P connector terminal No. 1 to
body ground with a jumper wire.
＊０２
19. Check for continuity between ECM/PCM connector
terminal A20 and body ground.
＊０３
Is there continuity?
YES
−
NO
PCM (A20) and the FTP sensor, then go to step 26.
11-404
FTP SENSOR 3P CONNECTOR
VCC6 (YEL)
JUMPER WIRE
Wire side of female terminals
ECM/PCM CONNECTOR A (49P)
VCC6 (YEL)
Terminal side of female terminals
− Go to step 32.
Repair open in the wire between the ECM/
20. Turn the ignition switch to LOCK (0).
21. Jump the SCS line with the HDS.
22. Disconnect ECM/PCM connector A (49P).
23. Check for continuity between FTP sensor 3P
connector terminal No. 2 and body ground.
FTP SENSOR 3P CONNECTOR
FTP (LT GRN)
Wire side of female terminals
Is there continuity?
YES − Repair short in the wire between the ECM/
PCM (A27) and the FTP sensor, then go to step 26.
NO − Go to step 32.
＊０４