Honda Accord 2008 Manual page 736

07/11/02 09:20:01 61TA0000_110_0417
15. Connect the vacuum pump/gauge, 0 30 in.Hg, to
the vacuum hose (A) as shown.
＊０４
A
16. Start the engine, and let it idle.
Is there vacuum?
YES
−
NO
between the throttle body and the EVAP canister
purge valve, then go to step 24.
17. Turn the ignition switch to LOCK (0).
18. Remove the FTP sensor with its connector
connected (see page 11-430).
− Go to step 17.
Check for blockage at the EVAP purge line
− 19. Connect a T-fitting (A) from the vacuum pump/
gauge, 0 30 in.Hg, and the vacuum pump, to the
FTP sensor (B) as shown.
20. Turn the ignition switch to ON (II).
21. Check and record the FTP SENSOR reading in the
DATA LIST with the HDS.
22. Slowly apply about 1.3 kPa (0.4 in.Hg, 10 mmHg) of
vacuum to the hose.
23. Check the FTP SENSOR in the DATA LIST with the
HDS.
Does the value change?
YES −
canister port, then go to step 24.
NO −
then go to step 24.
−
07JAZ-001000B
A
Check for debris or blockage at the EVAP
Replace the FTP sensor (see page 11-430),
＊０５
B
(cont'd)
11-417