Evap Canister Replacement - Honda Accord 2008 Manual

07/11/02 09:20:25 61TA0000_110_0428
EVAP System

EVAP Canister Replacement

1. Lift the vehicle on the hoist.
2. Remove the wheel sensor harness clamps (A)
＊０１
A
B
103 N·m
(10.5 kgf·m, 76 lbf·ft)
Replace.
3. Support the rear subframe with a transmission jack
and a wooden block as shown.
4. Remove the rear subframe mounting bolts (B) and
(C).
5. Lower the transmission jack and rear subframe
about 50 mm.
NOTE: Be careful not to damage the connecting
parts.
11-428
B
103 N·m
(10.5 kgf·m, 76 lbf·ft)
Replace.
C
27 N·m
(2.8 kgf·m, 20 lbf·ft)
6. Remove the bolt (A), and disconnect the hoses (B),
the EVAP canister vent shut valve 2P connector (C),
and the FTP sensor 3P connector (D).
B
A
9.8 N·m
A
(1.0 kgf·m,
7.2 lbf·ft)
7. Remove the bolts (E), then remove the EVAP
canister assembly (F).
ＴＡ０８ＡＥ４Ａ２０３２３４２５２１１ＫＢＡＴ００
D C B
F
E
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
＊０２