Subaru IMPREZA GD 2007 Series Manual page 2364

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分
12) Disconnect the oil outlet hose from pipe.
13) Take out the turbocharger from engine com-
partment.
B: INSTALLATION
CAUTION:
When replacing the turbocharger, check the fil-
ter part of union screw for clogging. <Ref. to
LU(H4DOTC)-24, INSPECTING UNION SCREW
WITH FILTER, INSPECTION, Oil Pipe.>
1. EXCEPT FOR STI MODEL
1) Connect the oil outlet hose to outlet pipe.
2) Install the turbocharger to intake duct.
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Turbocharger
3) Install the oil inlet pipe to turbocharger.
NOTE:
Use a new gasket.
Tightening torque:
T1: 16 N·m (1.6 kgf-m, 11.6 ft-lb)
T2: 29 N·m (3.0 kgf-m, 21.7 ft-lb)
T3: 4.9 N·m (0.50 kgf-m, 3.6 ft-lb)
T3
IN-00024
(B)
(A) Oil inlet pipe
(B) Metal gasket
4) Install the turbocharger bracket RH, and connect
the engine coolant hose to the pipe.
Tightening torque:
33 N·m (3.4 kgf-m, 24.6 ft-lb)
IN-00024
5) Install the joint pipe to turbocharger.
NOTE:
Use a new gasket.
Tightening torque:
35 N·m (3.6 kgf-m, 25.8 ft-lb)
IN-00074
IN(H4DOTC)-17
INTAKE (INDUCTION)
T1
(A)
(B)
T2
(B)
IN-02186
IN-02201
IN-00019