Subaru IMPREZA GD 2007 Series Manual page 2384

asieps_tobira_IM_US.book 13 ページ ２０１２年１月１７日 火曜日 午後３時４８分
15) Remove the crank sprocket.
16) Remove the bolts which install oil pump onto
cylinder block.
NOTE:
When disassembling and checking the oil pump,
loosen the relief valve plug before removing the oil
pump.
17) Remove the oil pump by using flat tip screw-
driver.
CAUTION:
Be careful not to scratch mating surfaces of
cylinder block and oil pump.
Oil Pump
B: INSTALLATION
Install in the reverse order of removal.
Perform the following.
1) Using the ST, install the front oil seal.
NOTE:
Use a new front oil seal.
ST 499587100
LU-02111
2) Apply liquid gasket to the mating surfaces of oil
pump.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
LU-00015
(A) O-ring
3) Apply a coat of engine oil to the inside of oil seal.
LU-00016
LU(H4DOTC)-13
LUBRICATION
OIL SEAL INSTALLER
ME-00164
(A)
ME-00165
LU-00018