asieps_tobira_IM_US.book 18 ページ 2012年1月17日 火曜日 午後3時48分
INTAKE (INDUCTION)
6) Connect the engine coolant hose which is con-
nected to the coolant filler tank.
7) Lift up the vehicle.
8) Install the center exhaust pipe. <Ref. to
EX(H4DOTC)-11, INSTALLATION, Center Ex-
haust Pipe.>
9) Connect the ground cable to the battery.
2. STI MODEL
1) Connect the oil outlet hose to outlet pipe.
2) Install the turbocharger to intake duct.
Tightening torque:
3 N·m (0.3 kgf-m, 2.2 ft-lb)
Turbocharger
3) Inall the oil inlet pipe to turbocharger, and con-
nect the flare joint.
CAUTION:
In order to prevent damaging the oil pipe on the
cylinder head side, fix the section (a) shown in
the figure when tightening the oil inlet pipe flare
nut, and avoid the part from rotating together
while tightening the nut.
IN-00174
NOTE:
Use a new gasket.
Tightening torque:
Union bolt
16 N·m (1.6 kgf-m, 11.8 ft-lb)
Flare joint
20 N·m (2.0 kgf-m, 14.8 ft-lb)
FU-00009
4) Install the turbocharger bracket RH, and connect
the engine coolant hose to the pipe.
Tightening torque:
33 N·m (3.4 kgf-m, 24.6 ft-lb)
IN-00024
IN-00074
IN(H4DOTC)-18
(a)
LU-02511
IN-00022
IN-00172