asieps_tobira_IM_US.book 18 ページ 2012年1月17日 火曜日 午後3時48分
LUBRICATION
14) Remove the nuts which install front cushion
rubber onto front crossmember.
15) Remove the bolts which install oil pan on cylin-
der block with the engine raised up.
16) Insert the oil pan cutter blade into the gap be-
tween cylinder block and oil pan.
CAUTION:
Do not use a screwdriver or similar tool in place
of oil pan cutter.
17) Remove the oil strainer.
18) Remove the baffle plate.
(D)
(C)
(B)
(A)
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
Oil Pan and Strainer
B: INSTALLATION
NOTE:
Before installing the oil pan, clean the mating sur-
face of oil pan and engine block.
1) Make sure that the seals (A) are installed se-
curely on the baffle plate in a direction as shown in
the figure below.
NOTE:
Use a new seal.
LU-02206
2) Install the baffle plate.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
3) Install the oil strainer to the cylinder block.
NOTE:
Use new O-rings.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
4) Tighten the oil strainer stay together with the baf-
fle plate.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
5) Apply liquid gasket to the mating surfaces, and
install the oil pan.
NOTE:
Install within 5 min. after applying liquid gasket.
Liquid gasket:
THREE BOND 1207C (Part No. 004403012) or
equivalent
LU-02334
LU(H4DOTC)-18
(A)
LU-00052
LU-00034