Subaru IMPREZA GD 2007 Series Manual page 2390

asieps_tobira_IM_US.book 19 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6) Tighten the bolts which secure the oil pan to the
engine block.
Tightening torque:
T1: 5 N·m (0.5 kgf-m, 3.6 ft-lb)
T2: 6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
T3: 10 N·m (1.0 kgf-m, 7.4 ft-lb)
(D)
(C)
(B)
T3
(A)
T1
(A) Oil pan
(B) Oil strainer
(C) Baffle plate
(D) Cylinder block
7) Lower the engine onto front crossmember.
8) Tighten the nuts which install front cushion rub-
ber onto front crossmember.
Tightening torque:
83 N·m (8.5 kgf-m, 61 ft-lb)
9) Install the front exhaust pipe. <Ref. to
EX(H4DOTC)-8, INSTALLATION, Front Exhaust
Pipe.>
10) Install the under cover.
Oil Pan and Strainer
11) Lower the vehicle.
CAUTION:
When lowering the vehicle, lower the lift-up de-
vice and wire ropes at the same time.
12) Remove the lifting device and wire ropes.
13) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T2
T1
LU-02335
14) Install the radiator upper brackets.
15) Install the intercooler. <Ref. to IN(H4DOTC)-
14, INSTALLATION, Intercooler.>
LU-02206
LU(H4DOTC)-19
LUBRICATION
LU-00028
T2 T1
ME-00218
CO-00090